Keyfit Tools Paver Puller PRO 9-Inch 2-Piece Set – Contractor-Grade 4140 Heat-Treated Steel With Joint Scraper & Gripper Slots – Pull, Lift & Remove Sunken Pavers, Bricks & Stones Locked By Edging

About This Product

Alright, so if you do any kind of paver work, you know how much of a pain it is when a brick gets sunken in or locked tight by edging.
That’s exactly where this Keyfit Tools Paver Puller PRO comes in clutch.

It’s a 2-piece set, each bar is 9 inches long and 1 inch wide, and they’re made from legit 4140 steel that’s been heat treated and case hardened.
None of that flimsy stainless steel junk that bends the first time you really lean into it.
These things are tough, with a hard coat zinc plating to keep rust away too.

What makes ’em smart is the design – they’ve got micro teeth on the joint scraper and gripper slots that help you get a solid bite on the paver without chewing up the edges.
The trick is to work all four sides back and forth to get a little gap, then go opposite ends and ease the block up a bit at a time.

Don’t try to pry both sides at once or you’ll bend the tool or crack the brick – take it slow, work it side to side, and it’ll come right out.
Great for raising sunken pavers that are sitting on sand or polymeric sand.

Now, fair warning – if your pavers are glued down with adhesive or set in concrete, this ain’t gonna do the job.
But for everything else?

It’s a beast.

Made in the U.
S.

A.
, patented design, and honestly, it’s one of those tools you’ll reach for again and again if you do patios, walkways, or driveways.
Landscape contractors swear by these, and once you use ’em, you’ll see why.