Drill Dust Cover Collector – Scalable Rubber Bowl For Electric Drill Bits Under 5.9 Inches, Fits Hammer Drills & Hand Drills, 1-Pack

About This Product

If you've ever drilled into a ceiling or a wall and gotten a face full of dust, you know how much it sucks.
This little dust cover collector is here to save you from that mess.

It's basically a rubber bowl that fits around your drill bit and catches all the debris before it rains down on you or your floor.

It works with drill bits under 5.

9 inches (141mm) and fits electric hammers, percussion drills, and standard hand drills.

The body is made of non-toxic, odorless rubber that's flexible enough to press against the surface and create a seal, so dust gets trapped inside instead of flying everywhere.
Plus it's scalable, so it adapts to different bit sizes and movements without getting in your way.

Using it on a side wall is dead simple – just mark your hole, press the collector against the wall, and drill right through it.
For ceiling work, you'll need to attach the included gaskets (black for round bits, blue for square bits) and secure them with the provided wire, then pop on the white inner sleeve.

Takes about a minute to set up once you get the hang of it.

Cleaning is quick – just dump the dust out and you're good to go.

It saves you from breathing in all that crap and cuts way down on cleanup time.
If you do a lot of drilling indoors, especially overhead, this thing is a no-brainer.