Uxcell Die Stock Handle – Threading Wrench For M10-M11 / 20-30mm Round Dies

About This Product

If you do any kind of thread repair or bolt making, you know a good die stock makes all the difference.

This one from uxcell fits round dies in the M10 to M11 size range, or any die with an outside diameter between 20mm and 30mm.
It's made from tool and alloy steel with a chrome plating that gives it serious hardness, wear resistance, and handles heat pretty well too.
There are five adjustable screws to lock your die in place securely, and you'll want to line up the die's positioning groove with that center screw before tightening.

Total length is about 10 inches, with handles just over 3.

5 inches long.
A quick tip: back it off a quarter to half turn every so often to clear chips, and don't forget a little cutting oil on the die edge when you're tapping threads—it'll save you a ton of frustration.

Fits round dies with capacity M10-M11 / 20mm-30mm OD.

Constructed from tool steel and alloy steel with chrome plating for high hardness, wear resistance, and heat resistance.
Ideal for repairing damaged bolts and threads or removing bolts and threaded rod when used with compatible round dies (not included).

Features adjustable screws for secure die holding and easy operation.
Align die positioning groove with the center fastening screw before tightening.

Reverse every 1/4–1/2 turn to clear chips; apply suitable lubricating oil to the die cutting edge during thread tapping.