INTBUYING Electric Rebar Bender – 4KW 220V 3-Phase, 0-180° Bending, Foot Pedal Control, For Steel Bar Up To 2" Diameter (GW50J)

About This Product

If you're working on a construction site or in civil engineering, bending rebar by hand is a nightmare.
This INTBUYING electric bender handles it like it's nothing.
The GW50J model runs on 220V three-phase power with a 4KW motor, and it'll bend round steel bar from 1/4-inch all the way up to 2 inches in diameter.
It also handles HRB400 ribbed steel up to 1.
7 inches – that's serious capacity.

Bending angle is fully adjustable from 0 to 180 degrees, and the working disc is about 16 inches across.
You get two speeds – 10 r/min for normal work, and 5 r/min for more control on harder materials.
The controls are dead simple: buttons and knobs for setup, and a foot pedal that lets you start the bend hands-free.
Step on it, and the machine does the rest.

This thing is built like a tank – sturdy iron body, high-strength idler wheels, and a clamping system that holds the bar tight to reduce waste.
It also has an emergency stop and auto-stop for safety.
Weighs about 850 pounds, so it's not going anywhere once it's in place.
Two lifting hooks make it easier to move around the job site.

Product Information