Sigma ProConnex 1/2-Inch EMT Inside Corner Pull Elbow – Zinc Die-Cast, Set Screw, Concrete-Tight, 2-Pack (Gray)

About This Product

If you’re running EMT conduit and need to make a sharp 90-degree turn in a tight spot, this Sigma inside corner pull elbow is just the ticket.
It’s sized for 1/2-inch conduit and comes in a convenient 2-pack, so you can handle a couple of bends or have a spare for the next job.
The gray finish matches standard conduit, and the die-cast zinc steel construction is seriously tough – no flimsy metal here.

What’s handy about these elbows is the set screw design.
You just slide your conduit in, tighten the screws, and you’ve got a solid, grounded connection that won’t slip.

The cover is removable too, which makes pulling wires through that bend way less frustrating – you can access the interior to guide your conductors without fighting the angle.

Plus, they’re rated for concrete-tight installations if you tape them properly, so they’re good for embedded or damp locations.

These are perfect for commercial or residential electrical work where space is limited, like behind walls, in ceiling plenums, or near panel boxes.

The 90-degree bend lets you route your conduits neatly and professionally without kinking wires or exceeding bend radius limits.

And since they’re from Sigma – a brand that knows electrical fittings – you’re getting reliable, code-compliant parts that inspectors will approve.

Each pack includes two complete elbows with screws and covers, so you’re ready to go right out of the box.

Whether you’re a licensed electrician or a serious DIYer doing a basement finish, these elbows save time and frustration.
No more battling with benders or oversized pull boxes – just clean, compact corners that make wire pulls easy.

Grab a pack and keep your conduit runs looking sharp and working right.