MECCANIXITY Cable Puller Socks – Single Head Wire Threader, 15-20mm & 20-25mm, Galvanized Steel, 56cm

About This Product

Pulling wire through conduit can be a pain, but these cable puller socks make it way easier.

This set gives you two different sizes – one for 15-20mm wire and one for 20-25mm – so you're covered for a range of cable diameters.
They're made of galvanized steel, so they're rust-resistant, tough, and flexible enough to bend around corners.

The mesh design actually tightens under tension – the harder you pull, the tighter it grips the cable.

That means no slipping, no scratching, and no damaged wires.

There's also an aluminum protective case that adds extra grip and prevents wear.
Length is about 56cm, giving you plenty of grip surface.

These are super handy for electrical installation, maintenance, or any job where you need to thread wire through pipe or conduit – homes, businesses, industrial sites, you name it.

They're reusable and simple to use: just slide the cable in, pull, and when you're done, push the mesh back to release.

Thinner wires might need a little extra reinforcement, but overall, these work like a charm.

Solid tool for any sparky's kit.