Cross Slide Drill Press Vise – Mini 2-Way Post Vice Bench Clamp For X-Y Milling, Fits 0618, 7x10, 12, 14 Inch Lathes

About This Product

If you're working on a small lathe or milling machine and need precise X-Y movement for drilling, turning, or boring, this cross slide vise is a handy addition to your bench.

It's made from HT250 grey iron – that's a tough, wear-resistant material that holds up under steady use.

The clamping block is about 50mm square (roughly 2 inches), and the slide block has a stroke of about 63mm (2.

5 inches).
The total plate length is around 120mm (4.

7 inches).
The two-way design lets you move tools both longitudinally and laterally, so you can make fine adjustments without repositioning your workpiece every time.
Compatible with 0618, 7x10, 12, and 14-inch mini lathes.
Comes with bottom fixing holes for easy mounting, and it's sturdy enough to support longer workpieces with a rear center.

Installation is straightforward – just bolt it down and you're set.
Great for drills, reamers, and turning tools.

If your lathe setup needs more flexibility, this vise delivers.